Phone:0710-3552030、13871636870
产品属性

Anaerobic Flange Sealant 574

广东省某某某科技有限公司
联系方式: 13622225555
官方微博: 广东某某有限公司
地址: 广东省珠海市香洲区XXX街道666号8楼233室
产品介绍

Anaerobic flange sealant 574



Product Description

574 seals close-fitting joints between rigid metal faces and flanges. The product cures when confined in the absence of air between close-fitting metal surfaces. It provides resistance to low pressures immediately after assembly. Typically used as a form-in-place gasket on rigid flanged connections 


Technical Data Sheet:

PRODUCTMAX GAP FILLING (mm)VISCOSITY 25°C (mPa s)COLORFULL CURE TIME(h)SHEAR STRENGTH (psi)TEMPERATURE RANGE °CDESCRIPTION
5740.2570000/120000ORANGE241232-54 +150machined and rigid metal flanges




How to use 

1. For best performance bond surfaces should be clean and free from grease and other contaminants.
2. The product is designed for close fitting flanged parts with gaps up to 0.25 mm (0.01 in).
3. Apply manually as a continuous bead, a rolled film or by screen printing to one surface of the flanges. For gaps greater than 0.125mm (0.005 in) using a pen roller, a rolled film should be applied to both flange surfaces.
4. Low pressures (<0.05 MPa, <7 psi) may be used when testing to confirm a complete seal immediately after assembly and before curing.
5. Flanges should be tightened as soon as possible after assembly to avoid shimming.



Package:

50ml, 20kg





Anaerobic flange sealant 574



Product Description

574 seals close-fitting joints between rigid metal faces and flanges. The product cures when confined in the absence of air between close-fitting metal surfaces. It provides resistance to low pressures immediately after assembly. Typically used as a form-in-place gasket on rigid flanged connections 


Technical Data Sheet:

PRODUCTMAX GAP FILLING (mm)VISCOSITY 25°C (mPa s)COLORFULL CURE TIME(h)SHEAR STRENGTH (psi)TEMPERATURE RANGE °CDESCRIPTION
5740.2570000/120000ORANGE241232-54 +150machined and rigid metal flanges




How to use 

1. For best performance bond surfaces should be clean and free from grease and other contaminants.
2. The product is designed for close fitting flanged parts with gaps up to 0.25 mm (0.01 in).
3. Apply manually as a continuous bead, a rolled film or by screen printing to one surface of the flanges. For gaps greater than 0.125mm (0.005 in) using a pen roller, a rolled film should be applied to both flange surfaces.
4. Low pressures (<0.05 MPa, <7 psi) may be used when testing to confirm a complete seal immediately after assembly and before curing.
5. Flanges should be tightened as soon as possible after assembly to avoid shimming.



Package:

50ml, 20kg